Select your countryX Close

< Back to the list


09/26/2014

Street Skates

WARNING
These skates do not have a brake and is intended for highly skilled and expert skaters.

UFS- Universal Frame System:
The inline skating industry has embraced a standard frame attachment for their
consumers. It gives you the freedom of choice to customize and personalize your skate to fit your own unique style. The distance between the frame mounting points is the same throughout the entire industry.

Rollerblade® TRS Frame UFS
The Rollerblade® UFS frame will fit up to a 60 mm wheel. It has a groove between
the second and third wheel. It also includes flush axles (8 mm of diameter) and can be adjusted with a single tool.

Rollerblade® Switch Frame UFS
The Rollerblade® Switch UFS frame will fit up to a 72 mm wheel with the frame spacers positioned to the up position. The 2nd and 3rd frame spacers can be positioned so that a 56mm wheel can be used to ride flat with 72mm wheels in the 1st and 4th wheel positions. The split of the 2nd and 3rd wheels can be adjusted from 10mm to 118mm by flipping the frame spacers. If you desire to use a wheel smaller than 72mm, the 1st and 4th frame spacers need to be positioned in the down position. This will prevent frame drag while turning. The Switch frame also includes flush axles (8 mm of diameter) and can be adjusted with a single tool.

Removing and Replacing the Frame
Remove the 2nd and 3rd wheels.
Remove the rear screw using Allen key #4.
Place frame on the bottom of shell/sole plate and insert new screws.
Tightly secure screws.
Replace the 2nd and 3rd wheels.

Note: Rollerblade® recommends replacing the screws with new ones when reconnecting the frame. If the screws become loose, additional thread lock may be added.

Removing and Replacing Grinding Inserts and Sole Plate
Remove the sole plate insert screws using included Allen key #3.
Remove the sole plates.
Replace the new sole plates, screws and plastic washers under front 4 screws.
Insert new screws, washers and tighten securely.

Note: Rollerblade® recommends replacing the screws with new ones when reconnecting the frame. If the screws become loose, additional thread lock may be added.

To Close the 45° Buckle
Slip the buckle strap into the receiver without pulling the buckle lever.
Ratchet the buckle lever to tighten the strap to the desired fit.

To Open the 45° Buckle
Pull the button of the receiver.
Pull out the strap from the receiver.